INOVA Gates Warranty & Hand-
Once the INOVA sliding gate product is completely installed, our INOVA gate Engineer's will demonstrate all the necessary elements to the
client/ contractor before the gate and automation systems are handed over, these elements are as follows;
1. Demonstrate "ALL" entry options on system (e.g. remote controls, keypad etc).
2. Demonstrate "ALL" exit options on system (e.g. Ground loops, swipe system etc).
3. Demonstrate "ALL" safety features and elements on the gate.
4. Demonstrate how to engage manual release in event of emergency.
5. Demonstrate how to re-
All INOVA sliding gates are covered under warranty for the first 12 months of the contract.
INOVA Gates Maintenance Agreement
Upon completion of this 12 month warranty period, the client has the option to take out a "maintenance agreement" with INOVA gates for
their gate product. Our maintenance agreements can be renewed annually.
This would involve our INOVA Gate Engineer's calling out to maintain your INOVA gate at your site location, under the INOVA gate
maintenance agreements terms and conditions, they are as follows;
-
-
Our annual maintenance agreement will include the following procedures on site:
(To be carried out by trained INOVA Gate Engineer's only)
1. Check all fixing anchors to main gate column, rear wheel and receiving post. Re-
2. Examine all rubber safety edges to ensure that each is working correctly (5 No).
3. Check all safety beams where applicable.
-
4. Inspect 5 lever door lock and cylinder for any signs of wear. Ensure all aspects of the lock are working correctly.
5. Carry out visual inspection inside cabinet for moisture, also checking that internal rubber seals on door are intact.
6. Check all terminal connections on PCB board to ensure no loose connections.
7. Examine all radio cards to ensure they are secure.
-
when gate is now outside of the support of main column, ensure that it is sufficiently safe and secure until work is carried out and Gate is
returned Into Main Column.
8. Check resistor and safety chain for wear.
9. Visually inspect all drive wheels and clean where necessary.
10. Lubricate torque jack with specific lubrication oil.
-
11. Re-
12. Make sure that torque handle is present inside the cabinet door.
-
13. Carry out visual inspection to ensure that main beam is at desired horizontal level.
14. Re-
15. Carry out visual inspection of all gate for any damage or corrosion relating to any damage caused.
It is in the best interest of the client that the annual maintenance agreement is taken out with INOVA Gates, to ensure that your INOVA
sliding gate is functioning correctly and safely throughout the life time cycle ......giving you complete peace of mind!!!
Copyright © 2011 Inova Gates Ltd . All rights reserved. Registered in UK -
Inova Gates Ltd Head Office
76 Derrynoid Road
Draperstown
Co. Derry
N. Ireland
BT45 7DW
Automatic Sliding Gates UK : Meta
Automatic gates UK and Ireland
Wrought iron gates
Safety on automatic doors and electric garage doors and roller garage doors
Automatic & automated iron gates
